Celair Profile Series Instrukcja Instalacji Pobierz pdf (Strona 4)

Installation Instructions

1.0 Introduction

Profile

1.2.3. Safety and O.H.&S. Requirements

• It is the responsibility of the dealer / installer to insure the environment is

safe for the installer to carry out the installation. A risk assessment should

be carried out in conformance to state codes of practice. An industry guide

to “safe Work at Heights” is available from Climate Technologies.

• It is the responsibility of the dealer / installer to ensure safe access to the

unit can be achieved for service and that the access conforms to the

relevant standards and codes.

• It is the responsibility of the dealer / installer to ensure the roof is provided

with access footings and platform where the pitch of the roof is unsafe for

service access.

• It is the responsibility of the dealer / installer to ensure harness anchorage

points are provided where units are located on a roof greater than single

story or if the pitch and roof construction do not allow safe access. See

Australian Standard 1891.4:2000 Part 4 Selection use and maintenance,

Table 2.1.

1.3. Before Commencing

• Packaging – check there is no damage before removing packaging. Damaged

units should not be installed. Climate Technologies should be contacted prior to

installation.

• Do not install damaged products. Contact your nearest Climate Technologies

office for further advice.

Installed damaged products will not be covered by warranty.

• Have you got all the system components?

• Have you got the right unit?

• Does the system design conform to the minimum specification of Celres

specification and as such fall in line with sound engineering design practices.

Page 4

1 2 3 4 5 6 7 8 9 ... 23 24

Brak uwag

Celair Profile Series Instrukcja Instalacji Strona 4